May 04, 2024 Leave a message

How To Remove The Cable From The Printhead Of Epson Printers

EPSON's C4X (C41, C43, etc.) series has a large number of users. If it is not used regularly, the ink in the printhead is likely to dry up or even block the print holes in places where the air is dry, especially in the north. In the case of cleaning the print head program operation is still ineffective, can only consider the print head removed for manual processing. At present, the Internet is circulating on the print head of violent disassembly of the article, I think this method for ordinary users may cause very serious consequences, this article will tell the reader how to correctly dismantle the printer printhead.


Preparation is in the online state to replace the cartridge operation, when the print head to move to the middle of the track can be unplugged, the purpose is to allow the print head from the printhead protection and locking device.


CAUTION: Performing the following operations will automatically void the warranty, so please think twice before doing so.
Please think twice before doing so and be careful.


Disassembling the printer and printhead

Step
1: Disassemble the printer 1.
Preparation: Push the front paper exit tray into the body, remove the paper feed frame, and use transparent tape to stick the transparent top cover to the white chassis. Tear off the blue adhesive strip at the joint between the top case (white) and the blue base, being careful to only expose the seam, do not tear it off as it will be used again when restoring the printer.

2.
Open the inner buckle card: At this point, you will see two obvious inner buckle cards on the back of the printer, use a small flat notch awl to push them apart, and then follow the exposed seam to push one of the two cards in the middle of the card as well, in this way, the back of the printer to uncover all the cards. Be careful to retain the exposed slit for later operation

 

3.
Slide a small, flat screwdriver along the seam toward the front of the printer, and you will encounter a total of four internal clasps on the left and right sides of the printer and on the front; open them in the same way. In this way, the top cover of the printer is separated from the base!

4.
Pinch the movable card of the paper feed opening and move it to the left (facing the printer) until it reaches the notch. At this point, lift the top cover upwards to remove it easily.
Step 2: Properly disassemble the print head

1.
Remove the print head: After removing the top cover of the printer, carefully observe the right side of the print head (facing the printer), you will find a card, with one hand to gently grasp the front of the print head compartment, the other hand with a flat mouth of a small pick to pry gently on that card, at this time, you will feel the front of the print head compartment on the right side of the outward movement of a little.
Unplug the printhead connecting cable and the ink cartridge monitoring chip cable (this cable needs to be clamped with a tool like hemostat) from the socket.
The printhead connection cable from the circuit board slot slowly pulled out, this time you can also see under the white cable on the left side of the printhead another card
If you use a small screwdriver to gently pry the clip, you can separate the front and rear compartments of the printhead by hand, and the printhead can be removed from the track at this point.
However, we also need to take off the traction rack from the word car on the right side of the motor gear: with a small flat mouth of the cone diagonally placed between the upper part of the gear and the rack, move the rack to the right, through the rotation of the gear can be taken off the rack from the gear!

2.
Disassemble the print head: After removing the print head, just use both hands to grab the front and rear bins of the print head respectively, and exert force horizontally in the opposite direction, you can easily disassemble the print head.
 

Send Inquiry

whatsapp

Phone

E-mail

Inquiry